- FOSHAN SUXUN MACHINERY CO.,LTD. You Are Welcome!
- The Service Hotline
- 13902422981
 
|
Characteristic
Suitable for the processing of symmetric and other types of processing, the partial swing movement and the feeding synchronization is completed, can save the material (single step) 3/4 above.
Shift sliding by high-speed linear bearings, guide rail with a special treatment, no noise, high wear resistance, load small friction, move fast and smoothly.
Partial discharge and feeding synchronization is completed, and the two dimension feed production efficiency is improved.
A microcomputer control system for servo (step motor).
Offset feeding times up to 30 times / minute.
Man machine interface control, simple operation.
The installation is simple and the signal is synchronized with the press.
This model is especially aimed at the circular products and the most common use of the material.
| Model TYPE |
Roller width (mm) |
Feeding form | Offset |
Material width (mm) |
Relax |
| OCP-100 | 100 | Standard feed offset feeding | Left right 50 | 0-2.0 | Pneumatic |
| OCP-200 | 200 | Standard feed offset feeding | Left right 100 | 0-2.0 | Pneumatic |
| OCP-300 | 300 | Standard feed offset feeding | Left right 150 | 0-2.0 | Pneumatic |
| OCP-400 | 400 | Standard feed offset feeding | Left right 200 | 0-2.0 | Pneumatic |
| OCP-500 | 500 | Standard feed offset feeding | Left right 250 | 0-2.0 | Pneumatic |
| OCP-600 | 600 | Standard feed offset feeding | Left right 300 | 0-2.0 | Pneumatic |
(1) high red hardness and wear resistance, good impact carbide; in no case impact load, should be used YT30, YT15, YG3 other tools materials. (2) The tool angle, in general, with the improvement of har...
Factors affecting the thin wall workpiece quality are: ⑴, deformation of the workpiece clamping force, affecting the dimensional accuracy and shape accuracy. ⑵, cutting heat-induced deformation of ...
Use with the knife while turning slender shaft, have a bamboo-shaped because the contact pressure with the tool holder claw support with the workpiece is too large. The correct approach is to use with ...
Turning the elongate shaft deformation and vibration causes are: ⑴, piece by cutting heat elongation bending deformation. ⑵, the workpiece bending and vibration in the cutting force. ⑶, workpiece...
400 phone：13902422981
Tel：0757-86690339
Fax：0757-86690339
Mobile：13902422981
QQ：214210961
Email：suxunmachine@163.com
Address：No.15 Workshop, Yuanxia jiuzhong Complex Building, south of Guanhua Road, Xindong Village, Guanyao, Shishan Town, Nanhai District, Foshan City
If you to our goods have what problem,Please ask advice!